Difficulty
Moderate
Steps
8
Time Required
00:45:00
- Stage 01: Hardware 8 steps
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
-
-
For this upgrade you will need a Raspberry Pi board. We recommend the Raspberry Pi 4 2GB for this.
-
Compatable boards:
-
Pi 3B+ (USB WiFi adapter required)
-
Pi Zero 2 W
-
There is a current shortage for these boards. Supply is returning, but we're struggling to secure any in bulk. You should be able to find local distributors selling them on a one per customer policy.
-
-
-
Fix the four Raspberry Pi standoffs to the Base with four M2.5 x 6mm bolts.
-
M2.5 x 10mm standoff
-
M2.5 x 6mm bolt
-
-
-
Strip the ends of the black and red power cable.
-
Connect one side to the USB power adapter as shown.
-
-
-
Due to an unfortunate oversight, you may have an M3 x 20mm bolt instead of an M4 x 20mm bolt and the 3D printed KIS3R33S bracket will have a 3mm hole instead of a 4mm hole. If this is the case see the next step.
-
Take the KIS3R33S bracket and use it to mount the USB adapter to the side of the PSU with an M4 x 20mm bolt.
-
Connect the wires to the +/- terminals as shown. Red to positive and black to negative.
-
-
-
Use two cable tie mounts to secure the KIS3R33S USB adapter to the base.
-
Connect the wires to the +/- terminals as shown. Red to positive and black to negative.
-
-
-
Connect the USB power cable from the adapter to the Raspberry Pi board.
-
-
-
Connect the blue USB cable frmo the BTT control board to the Raspberry Pi board.
-
-
-
Unclip the camera from the Pi Cam board.
-
Peel away the protective layer from the sticky pad underneath the camera module.
-
Secure the camera module back onto the baord.
-
Make sure that the connector also clicks in place.
-
