You're viewing a previously published revision of this guide.  View latest revision

Older
Aug 22, 2022 - 09:08:24
Jan 22, 2024 - 07:01:28 Nov 20, 2022 - 02:11:55 Aug 23, 2022 - 11:08:21 Aug 23, 2022 - 04:08:20 Aug 22, 2022 - 09:08:24 Aug 21, 2022 - 12:08:52 Nov 11, 2021 - 05:11:21 Nov 11, 2021 - 05:11:15 Nov 11, 2021 - 01:11:08 Nov 11, 2021 - 01:11:16 Nov 11, 2021 - 01:11:45 Nov 11, 2021 - 01:11:35 Nov 11, 2021 - 01:11:49 Nov 11, 2021 - 12:11:09
Newer

Stage 04: Wiring

Written By: Makertech 3D
  • Comments: 2
  • Favorites: 0

Difficulty

Moderate

Steps

2

Time Required

Suggest a time??

Sections

1

Flags

0

  1. Follow the layout in the PDF file below to wire the switching hotend for your board.

    • Follow the layout in the PDF file below to wire the switching hotend for your board.

    • We recommend installing the relay for reliability. Due to unknown reasons with either firmware or electrical noise, sending a "Pulse=0" command will sometimes cause random movement in the servo. So to power down the servo after each move we use this relay switch instead.

    • This step is especially recommended if you are using the Switching Hotend with Klipper Firmware.

Attached Documents

Author

Makertech 3D

Member since: 03/09/2018

43,952 Reputation

110 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 3

Past 30 Days: 17

All Time: 1,058