You're viewing a previously published revision of this guide.  View latest revision

Older
Nov 20, 2022 - 02:11:55
Jan 22, 2024 - 07:01:28 Nov 20, 2022 - 02:11:55 Aug 23, 2022 - 11:08:21 Aug 23, 2022 - 04:08:20 Aug 22, 2022 - 09:08:24 Aug 21, 2022 - 12:08:52 Nov 11, 2021 - 05:11:21 Nov 11, 2021 - 05:11:15 Nov 11, 2021 - 01:11:08 Nov 11, 2021 - 01:11:16 Nov 11, 2021 - 01:11:45 Nov 11, 2021 - 01:11:35 Nov 11, 2021 - 01:11:49 Nov 11, 2021 - 12:11:09
Newer

Stage 04: Wiring

Written By: Makertech 3D
  • Comments: 2
  • Favorites: 0

Difficulty

Moderate

Steps

2

Time Required

00:30:00

Sections

1

Flags

0

Quiz

0

  1. Follow the layout in the PDF file below to wire the switching hotend for your board.

    • Follow the layout in the PDF file below to wire the switching hotend for your board.

  2. We recommend installing the relay for reliability. Due to unknown reasons with either firmware or electrical noise, de-activating the servo via its signal line will sometimes cause random movement in the servo. So to power down the servo after each move we use this relay switch instead which physically disconnects the servos 5v line.

    • We recommend installing the relay for reliability. Due to unknown reasons with either firmware or electrical noise, de-activating the servo via its signal line will sometimes cause random movement in the servo. So to power down the servo after each move we use this relay switch instead which physically disconnects the servos 5v line.

    • This step is especially recommended if you are using the Switching Hotend with Klipper Firmware.

Attached Documents

Author

Makertech 3D

Member since: 3/9/18

51,265 Reputation

137 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 7

All Time: 1,495