Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
    • Download the Marlin firmware depending on your configuration:

    • 24V Heated Bed

    • MIC-6 Heated Bed

    • Copy the firmware.bin file over to the micro SD card.

    • Insert the SD card into your control board.

    • Download the displays firmware here.

    • Copy the files onto the SD card.

    • Insert the SD card into the display.

    • Double check all of your wiring with the wiring diagram here.

    • In particular, your wiring of the power supply and heated bed.

    • Powering on for the first time should result in the following:

    • The Touch Screen Display should power on and begin updating.

    • The Hotend cooling fan should spin.

    • The electronics fan should spin.

    • The LED's should light up.

    • Once the touch screen has been updated remove the SD card.

    • Delete the contents of the SD card, it should now be ready to use with your printer.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

    • Insert wisdom here.

Makertech 3D

Member since: 3/9/18

51,315 Reputation

137 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 1,306