Difficulty
Moderate
Steps
5
Time Required
- Stage 9: Calibration 5 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Private
This guide will not appear in search results and can only be viewed by team members!
Quiz
0
-
-
The Proforge 4 uses the CXC by Ember Prototypes to help calibrate the print heads. Learn more about the CXC here.
-
An auto-calibration tool is also in the works, it is scheduled for release in February 2024.
-
-
-
The CXC software currently only runs on Windows machines.
-
Download the software here.
-
Unzip the file and run setup.exe file.
-
-
-
Unpack the camera by taking it out of its anti-static packaging.
-
Use the cable to connect the camera to your computer.
-
When connected you should get a feed on the software like this.
-
-
-
Before starting make sure that your print heads are clear of any filament ooze.
-
Make sure that your current X/Y offset values are all set to 0. Double check this in the variable.cfg file.
-
Home the printer.
-
Lower the bed to 30mm.
-
Select T0
-
Move the print head to X/Y position (100, 100).
-
-
-
Place the camera module onto the platform - the module has a magnet underneath it which will stick to the platform.
-
Do not place the module onto the bed when it is hot - this can cause damage to the module.
-
Move the print head using the controls in Mainsail until the centre of the nozzle comes into focus and also lines up with the cross hairs of the camera feed.
-
When lined up hit start
-
