Changes to Step #6
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| - | [title] Filament Sensor and Motor Cable |
|---|---|
| + | [title] Filament Sensor and Motor Cable (Left Side) |
| [* 10] Take the filament sensor and motor cables together and fix with a cable tie to the top panel. | |
| [* 2] Route the cables down the 2040 extrusion as shown. Use electrical tape to cover the cables. | |
| [* 10] Make sure that the sides of the cable that are fixed to the top panel are those that are shown in the photo. | |
| [* 6] Motor cable | |
| [* 3] Filament sensor cable |