Changes to Step #11
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] LED Lights |
|---|---|
| + | [* 5] Stick the LED strip light to the inside front of the top panel. |
| + | [* 4] Route the cable down the front right side. Again, use electrical tape to hide and hold the cable in place. |
| + | [* 10] Wire the LED's directly to the power supply. |
| + | [* 2] Red to positive |
| + | [* 1] Black to negative |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added