Changes to Step #27
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Touch Screen Cables |
|---|---|
| + | [* 4] Black cable: This is for controlling the printer through the touch screen interface via serial. |
| + | [* 10] The two white cables are for controlling the printer directly via marlin's interface through ''emulation mode''. |
| + | [* 6] EXP 1 |
| + | [* 2] EXP 2 |
| + | [* 4] Black cable - board side. |
| + | [* 9] Note the orientation of the loose connector and the 4-pin connector, match as shown in the third image. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added