Changes to Step #4
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Preparing the Brackets |
|---|---|
| + | [* 10] There are three types of brackets that look similar. We need to take the ones shown and add M5 x 8mm bolts and T-nuts to as shown in the images. |
| + | [* 5] M5 x 8mm Button |
| + | [* 7] M5 T-nut |
| + | [* 9] Do not tighten down yet, just add the T-buts by a few turns. |
| + | [* 4] The first type only has 5mm holes around the edges. (x12) |
| + | [* 2] The second has one 6mm hole on the corner. (x4) |
| + | [* 9] The third - which is not used yet - has a threaded M4 hole on its diagonal edge. (x4) |
Image 1
No previous image
Added
Image 2
No previous image
Added