Changes to Step #2
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Mounting the Base to the Frame | |
| - | [* 10] Secure the base to the bottom of the frame, orientating it as shown. Tighten the bolts form the previous step against the extrusions on the bottom of the frame. |
| + | [* 10] Secure the base to the bottom of the frame, orientating it as shown. Tighten the bolts from the previous step against the extrusions on the bottom of the frame. |
| + | [* 7] Also add to each corner a rubber foot. |
| [* 5] M6 x 75mm Bolt | |
| - | [* 7] Also add to each corner a rubber foot. |
| - | [* 6] Align the foot so that it slots in place into the cutouts on the base. |
| + | [* 6] Align the foot so that it slots in place into the cutouts on the base. |