Changes to Step #13

Edit by Makertech 3D —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Mounting the Pi Board
[* 10] Mount the board to the base:
[* 5] M2.5 x 6mm bolt
[* 7] M2.5 x 10mm standoff
[* 6] Mount the board with the USB ports pointing to the left as shown.
-[* 11] ***Do not ***stick the antenna to the base. We've been told by BTT that this can cause signal issues if it is stuck onto metal. Instead leave it hanging.
+[* 11] ***Do not ***stick the antenna to the base as this may cause signal issues if it is stuck onto metal. Instead leave it hanging.