Changes to Step #19
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Mounting the Power Port | |
| + | [* 10] Push all of the cables attached to the power port into the base. |
| [* 10] Fix the power port to the rear of the base. | |
| [* 5] M3 x 10mm Counter Sunk Bolt | |
| [* 7] M3 Nyloc Nut | |
| - | [* 11] Push all of the cables attached to the power port into the base. |