Changes to Step #22
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Pi Power Wiring | |
| [* 10] Wire the power converter and BTT Pi as shown. | |
| [* 5] Power Convertor cables - 50cm | |
| [* 11] Connect from 24V PSU to 24V terminals on converter. | |
| [* 7] Pi power cables - 30cm | |
| [* 11] Connect from 24v terminals on the convertor to the BTT Pi. | |
| + | [* 9] If you are building v4.2 and using the Pi 2 board then polarity is reversed, check under the board to confirm that red is going to positive and black to negative. |