Changes to Step #15
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Preparing the Octopus MAX EZ Control Board |
|---|---|
| + | [* 9] Before unpacking the control board make sure that you have grounded yourself. You can do this by touching a large metal object. This is to prevent any static from damaging the control board when handling it. |
| + | [* 6] After unpacking the control board you should find a bag of jumpers. |
| + | [* 10] Use these jumpers to close connections between pins as shown on the diagram. |
| + | [* 2] Set fan voltages to board voltage (24v) |
| + | [* 4] Set thermistors to PT1000 |
| + | [* 5] Set gantry motors to 48V |
| + | [* 7] Set all other motors to board voltage (24v) |
| + | [* 3] Make sure there is ***NO*** jumper placed on theUSB power pins. |
Image 1
No previous image
Added
Image 2
No previous image
Added