Changes to Step #16
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] EZ Stepper Drivers |
|---|---|
| + | [* 9] Before unpacking the stepper driver boards make sure that you have grounded yourself. You can do this by touching a large metal object. This is to prevent any static from damaging the drivers when handling them. |
| + | [* 11] These drivers can only be plugged in one way. The fin side of the heatsink points towards the USB C port on the board. |
| + | [* 10] With the board placed on a flat/hard surface, like a table, carefully push the motor drivers into their slots. |
| + | [* 5] Plug the TMC5160 RGB EZ Drivers into the board as shown. They will drive the gantry motors. |
| + | [* 7] Plug the TMC2209 EZ Drivers into the board as shown. They will drive the Z motors and extruders. |
Image 1
No previous image
Added
Image 2
No previous image
Added