Changes to this Step

Edit by Bruce Segal —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Cable Tying
[* 6] Move the Gantry down to its lowest position.
[* 5] Arrange the Cables from the extruder assembly to stretch down to the Z-Axis Bracket.
[* 7] Securely cable tie all of the cables to the Z-Axis Bracket.
- [* 9] Make sure that the endstop cable is taught against the Y-Motor and not rubbing against the roller wheel as shown in the third image.
+ [* 9] Make sure that the endstop cable is taut against the Y-Motor and not rubbing against the roller wheel as shown in the third image.