Changes to Step #5
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Cable Tying Cont. |
|---|---|
| + | [* 6] Raise the Gantry to its highest position. |
| + | [* 3] Check that the extruder cables loop up like shown. |
| + | [* 5] Move the Print Platform out to the left with the back of the Proforge 2/2S facing you. |
| + | [* 2] Carefully lay it down on its side. |
| + | [* 9] Use a book (or a roll of tape like shown) to raise the top end up to prevent the extuder mount from being crushed. |