Changes to Step #7
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Hotend Wiring | |
| + | [* 9] If building with the Dual Switching Extruder upgrade this is Hotend #1 (on the left). |
| [* 5] Find the group of cables from the Hotend. | |
| [* 4] Hotend Heater Cables | |
| [* 6] Thermistor Cables | |
| [* 3] Hotend Fan Cables | |
| [* 4] Connect the Hotend heater cables to the ***HE0 ***terminal on the control board. | |
| - | [* 11] The +/- position of the cables is not important. |
| - | [* 11] You may need to unscrew the board from its mounts to properly access it. |
| + | [* 11] The +/- position of the cables is not important. You may need to unscrew the board from its mounts to properly access it. |
| [* 6] Connect the Thermistor cables to the TH1 connector on the board. |