Changes to Step #10
Step Lines
| - | [title] Fans |
|---|---|
| + | [title] Probe and Fans |
| [* green] Wind the exposed parts of the HotEnd Heatsink Fan wires and Probe wires together as shown. | |
| [* icon_note] Negative: Black (Fan) & Blue (Probe) | |
| [* icon_note] Positive: Red (Fan) & Brown (Probe) | |
| - | [* red] Connect the cables that you just wound together directly to the power supply as shown in the second image. |
| + | [* red] Connect the cables that you just wound together directly to the power supply as shown in the second image. |
| + | [* black] Connect the Negative Pair to any of the three negative terminals on the Power Supply. |
| [* blue] Connect the reming two black and red wires from the probe to the Z- postion on the board. | |
| [* icon_caution] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board. | |
| [* orange] Connect the Print Cooling Fan to the Board. |