Changes to Step #10

Edit by Makertech 3D —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Probe and Fans
[* 5] Wind the exposed parts of the HotEnd Heatsink Fan wires and Probe wires together as shown.
[* 10] Negative: Black (Fan) & Blue (Probe)
[* 10] Positive: Red (Fan) & Brown (Probe)
[* 2] Connect the cables that you just wound together directly to the power supply as shown in the second image.
[* 1] Connect the Negative Pair to any of the three negative terminals on the Power Supply.
-[* 7] Connect the reming two black and red wires from the probe to the Z- postion on the board.
+[* 7] Connect the Negative Pair to any of the three negative terminals on the Power Supply.
[* 9] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board.
[* 3] Connect the Print Cooling Fan to the Board.