Changes to Step #10
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Probe and Fans | |
| [* 5] Wind the exposed parts of the HotEnd Heatsink Fan wires and Probe wires together as shown. | |
| [* 10] Negative: Black (Fan) & Blue (Probe) | |
| [* 10] Positive: Red (Fan) & Brown (Probe) | |
| - | [* 2] Connect the cables that you just wound together directly to the power supply as shown in the second image. |
| - | [* 1] Connect the Negative Pair to any of the three negative terminals on the Power Supply. |
| - | [* 7] Connect the Negative Pair to any of the three negative terminals on the Power Supply. |
| - | [* 9] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board. |
| - | [* 3] Connect the Print Cooling Fan to the Board. |
| + | [* 1] Connect the cables that you just wound together directly to the power supply as shown in the second image. |
| + | [* 6] Connect the negative pair to any of the three negative terminals on the Power Supply. |
| + | [* 2] Connect the postive pair to any of the three positive terminals on the Power Supply. |