Changes to Step #18
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Z and X-Motor | |
| - | [* 5] Connect the Z-Motor to the Z position on the board. |
| - | [* 7] Connect the X-Motor to the X position on the board. |
| + | [* 5] Connect the Z-Motor to the Z position on the board with a 4-pin 50CM cable. |
| + | [* 7] Connect the X-Motor to the X position on the board with a 4-pin 50CM cable. |
| [* 10] Route the cables across the top of the power supply. |