Changes to Step #25

Edit by Makertech 3D —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Stepper Drivers
-[* 3] Prepare two of the A4988 Stepper Drivers by removing them from their packaging and sticking the Heatsink to the black chip.
+[* 3] Prepare two of the A4988 Stepper Drivers by removing them from their packaging and sticking the heatsink to the black chip.
[* 9] Make sure that the heatsink is not touching any of the pins. Orient the fins of the heatsink as shown.
[* 11] The kit also includes one spare A4988 Stepper Driver.
[* 6] ***Z-Axis Stepper:*** Adjust the trimpot so that flat side is pointing towards the bottom left corner as shown in the second photo.
[* 5] ***E-Axis Stepper:*** Adjust the trimpot so that flat side is pointing left as shown in the second photo.
[* 10] Fix the two Stepper Drivers onto the the control board as shown in the Z and E0 positions.
[* 9] Make sure that the screw trimpot side of the stepper drivers is pointing towards the touch screen. Installing a stepper driver the wrong way round will destroy it.