Changes to Step #26

Edit by Bruce Segal —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Stepper Drivers - Proforge 2S
[* 5] Prepare two of the A4988 stepper drivers and the two TMC2100 stepper drivers by removing them from their packaging and sticking on the heatsinks as shown in the images.
[* 10] Make sure the heatsink is not touching any of the pins.
- [* 10] Orientate the fins of the heatsink as shown.
+ [* 10] Orient the fins of the heatsink as shown.
[* 10] The Kit will have 5 A4988 Stepper dirvers in total, for the Proforge 2S you will only need to use two, the remaining are spares.
[* 7] Fix the two A4988 Stepper Drivers onto the the control board as shown in the Z and E0 positions.
[* 3] Fix the two TMC2100 Stepper Drivers to the X & Y Positions.
[* 9] MAKE SURE TO MATCH THE ORIENTATION AS SHOWN IN THE THIRD IMAGE.