Changes to Step #32
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Print Surface Sticker |
|---|---|
| + | [* 9] Before starting make sure the Metal Surface is ***clean***. If possible wipe down with an alchol rub to be certain. |
| + | [* 3] Partially remove the backing paper from the short side of the Print Surface Sticker. |
| + | [* 5] Align with the right edge of the Metal Surface on the Proforge 2/2S. |
| + | [* 5] Make sure it is equal distance from all the edges. |
| + | [* 2] Pull back the backing paper and apply pressure to the surface sticker to get it to stick down evenly. |
| + | [* 10] Make sure to avoid air bubbles. |
Image 1
No previous image
Added
Image 2
No previous image
Added