Stage 09 - Wiring Step #32 History

Changes to Step #32

Edit by Makertech — Jun 27, 2018

Edit approved by Makertech

	[title] Print Surface Sticker
	[* icon_caution] Before starting make sure the Metal Surface is *clean*. If possible wipe down with an alchol rub to be certain.
	[* orange] Partially remove the backing paper from the short side of the Print Surface Sticker.
	[* green] Align with the right edge of the Metal Surface on the Proforge 2/2S.
-	[* green] ~~Make sure it is~~ equal distance from all the edges.
+	[* green] Keep an equal distance from all of the edges.
	[* red] Pull back the backing paper and apply pressure to the surface sticker to get it to stick down evenly.
-	[* icon_note] ~~Make sure to avoid~~ air bubbles.
+	[* icon_note] Avoid air bubbles.