Changes to Step #13
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Probe and Fan Cont. | |
| [* 1] Connect the reming two black and red wires from the probe to the Z- postion on the board. | |
| + | [* 1] Make sure the red wire is going to S (signal) and the black wire is going to G (ground). The pins are marked between the connectors on the board. |
| + | [* 1] Connect the Print Cooling Fan to the Board. |