Changes to Step #20
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Dual Z-Motor Adapter | |
| [* 7] Connect the other ends of the motor cables to the dual z-motor adapter. | |
| - | [* 9] ***Make sure the the red cable is on the same side of the connector for both of the Z-motor Cables. If they are different swap a cable from one of the other motors.*** |
| + | [* 9] ***Make sure the the red cable is on the same side of the connector for both of the Z-motor Cables. If they are different swap with a cable from one of the other motors.*** |
| [* 3] Connect the adapter to the Z-motor position on the control board. |