Changes to Step #11
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Ceramic Washers |
|---|---|
| + | [* 10] Add to the heater block assembly two ceramic washers. |
| + | [* 5] M3 x 10mm Bolt |
| + | [* 2] M3 Ceramic Washer |
| + | [* 9] Fasten the bolt on by just a few turns, it will be tightened down in the next step. |
| + | [* 10] Repeat this for the number of print heads you're building. |
Image 1
No previous image
Added
Image 2
No previous image
Added