Changes to Step #3
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Right Panel Prep |
|---|---|
| + | [* 10] Take the right panel and remove the protective film from it. |
| + | [* 10] Prepare the panel by loosely adding onto it fasteners. |
| + | [* 5] M4 x 8mm Bolt |
| + | [* 2] M4 T-nut |
| + | [* 9] Match the orientation as shown in the diagram about which side the bolts and nuts should be on. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added