Changes to Step #3
Edit by Chris —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Right Panel Prep | |
| [* 10] Take the right panel and remove the protective film from it. | |
| [* 10] Prepare the panel by loosely adding onto it fasteners. | |
| - | [* 5] M4 x 8mm Bolt |
| - | [* 2] M4 T-nut |
| + | [* 5] M4 x 8mm Bolt (10) |
| + | [* 2] M4 T-nut (10) |
| [* 9] Match the orientation as shown in the diagram about which side the bolts and nuts should be on. |