Changes to Step #5
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Rear Panel and Filter Fan |
|---|---|
| + | [* 10] Take the rear panel and remove the protective film from it. |
| + | [* 10] Take the 70mm blower fan and fix it to the panel. |
| + | [* 5] M4 x 40mm |
| + | [* 2] M4 Nyloc Nut |
| + | [* 9] Make sure to install the fan on the side shown in the diagram. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added