Changes to Step #23
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| - | [title] Bed Levelling |
|---|---|
| + | [title] Manual Bed Levelling |
| [* 1] You can power off the Proforge 2/2S whilst doing this step. | |
| [* 1] Move the nozzle to the highest corner on the print surface. Take care to not drag the nozzle accross the platform! | |
| [* 7] ***Adjust the z-axis*** to make the gap between the nozzle and the print surface small enough that you are able to pass a folded piece of paper between it with just a little friction. | |
| [* 9] For the rest of this process keep the z-axis fixed. | |
| [* 3] Move the Hotend to one of the other corners and repeat but, this time turn the screw on the platform to raise the bed to meet the nozzle. Hold the standoff with a pair of pliars to prevent the entire assembly from coming undone. | |
| [* 1] Repeat for the remaining two corners. | |
| [* 1] Check that the nozzle at this fixed z-position is level across the four corners of the print surface with the gap being as small as a width of a piece of paper folded in half. |