Changes to Step #2
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Servo Relay Wiring |
|---|---|
| + | [* 10] We recommend installing the relay for reliability. Due to unknown reasons with either firmware or electrical noise, sending a "Pulse=0" command will sometimes cause random movement in the servo. So to power down the servo after each move we use this relay switch instead. |
| + | [* 9] This step is especially recommended if you are using the Switching Hotend with Klipper Firmware. |