Changes to Step #2
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Servo Relay Wiring | |
| [* 10] We recommend installing the relay for reliability. Due to unknown reasons with either firmware or electrical noise, de-activating the servo via its signal line will sometimes cause random movement in the servo. So to power down the servo after each move we use this relay switch instead which physically disconnects the servos 5v line. | |
| [* 9] This step is especially recommended if you are using the Switching Hotend with Klipper Firmware. | |
| + | [* 11] The two signal pins are unique. |