Changes to Step #5
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Probe Setting |
|---|---|
| + | [* 3] Set z-probe for homing. |
| + | [* 5] Define nozzle/probe offset. |
| + | [* 10] {39.5, 32, 0} |
| + | [* 10] Probe Pins: |
| + | [* 10] As mentioned before, in the wiring diagram, the probe's black cable needs to be connected to a digital signal pin on your control board. You can set this pin number by entering the following into either your configurtion.h file or directly into your boards pins.h file. |
| + | [* 8] In lib/src/pins/...your control board |
| + | [* 8] Here, the Z_MIN_PROBE_PIN is pointing to pin 4. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added