Changes to Step #6
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Servo Settings |
|---|---|
| + | [* 10] Similarly, in the wiring diagram, the servos orange cable needs to be connected to a digital signal pin on your control board. You can set this pin number by entering the following into either your configurtion.h file or directly into your boards pins.h file. |
| + | [* 10] In lib/src/pins/...your control board |
| + | [* 6] Here, the SERVO0_PIN is pointing to pin 5. |
Image 1
No previous image
Added