Changes to Step #11
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Inspecting and Calibrating the Print |
|---|---|
| + | [* 10] The two parts of the Calibration Print will likely be either over-lapping each other or be leaving a gap. |
| + | [* 10] Depending on how the print looks we will adjust the X/Y offsets in Cura with the aim of getting the two parts to line up. |
| + | [* 2] Offsets are entered in Machine Settings under the ***Hotend #2*** Tab. |
Image 1
No previous image
Added