Changes to Step #12
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Deciding the X-Offset |
|---|---|
| + | [* 3] Overlapping in X Direction: |
| + | [* 10] Decrease/Negative X-Offset |
| + | [* 7] Gap in X Direction: |
| + | [* 10] Increase/Positive X-Offset |
| + | [* 2] In our case the print was fine in the X-Direction, so we left our X-offset as 0. |
| + | [* 11] For example, if there had been a gap of 0.25mm, our offset would have been ***0.25mm***. |
| + | [* 11] An overlap of 0.25mm would have meant an offset of ***-0.25mm.*** |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added