Changes to Step #13
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Deciding Y-Offset Value |
|---|---|
| + | [* 3] Overlapping in Y Direction: |
| + | [* 10] Decrease/Negative X-Offset |
| + | [* 7] Gap in Y Direction: |
| + | [* 10] Increase/Positive X-Offset |
| + | [* 2] In our case the print had a gap in the Y Direction, so we set our Y-offset to ***0.7mm.*** |
| + | [* 11] If there had been an overlap of 0.7mm, our offset would have been ***-0.7mm***. |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added