Changes to Step #2
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Z-Rod Brackets | |
| [* 4] Fix the four metal brackets to the sides of the base. | |
| [* 2] Bracket | |
| [* 7] M5 x 3mm Spacer | |
| [* 8] M5 x 16mm Button | |
| [* 5] M5 Nyloc Nut | |
| - | [* 9] Do not tighten yet, leave the bracket fixed loosely. |
| + | [* 9] Do not tighten yet, just hand fasten to leave the bracket fixed loosely. |
| [* 9] Make sure the bolt on the bracket is facing outwards and away from the centre of the base panel. |