Changes to Step #3
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Electronics Fan |
|---|---|
| + | [* 10] Install the electronics fan as shown: |
| + | [* 3] Make sure the sticked side of the fan points inwards. |
| + | [* 8] Make sure the cable is also orientated as shown. |
| + | [* 7] M3 x 20mm CAP |
| + | [* 5] M3 Nyloc |
Image 1
No previous image
Added
Image 2
No previous image
Added