Changes to Step #7

Edit by Makertech 3D —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Power Switch
-[* 5] Disassemble the switch assembly by pulling the adapted off the switch and undoing the nut.
+[* 5] Disassemble the switch assembly by pulling the adaptor off the switch and undoing the nut.
[* 4] Push the switch in though the hole at the front of the base.
-[* 6] Fix the switch in place by tightening the nut back onto it.
+[* 6] Fix the switch in place by tightening the nut back onto it. DO NOT OVERTIGHTEN.
[* 2] Plug the cable adapter back on, note the orientation, the side with the release lever should go on the side that has the tab on the switch housing.