Changes to Step #2
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Dissassembling the Platform | |
| [* 1] Begin by disassembling the platform from the base. | |
| [* 1] Do this by first untying the belt from the platform. | |
| [* 1] Then remove the heated bed and place it to one side, you don't need to disconnect its wiring. | |
| + | [* 1] If you have the Pi Camera installed, unmount it also, again you don't need to disconnect it from the pi board. |
| [* 1] Finally, remove the old HDPE linear guides holding the platform in place. | |
| + | [* 1] The platform should now be free for the next step of drilling the holes for the linear rails. |