Changes to Step #3
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| - | [title] Disassembling the Gantry and Z-Pillar |
|---|---|
| - | [* 1] Next remove the tool carraige from the gantry. |
| + | [title] Disassembling the Gantry |
| + | [* 1] Next, remove the tool carriage and Y-belt from the gantry. Do not cut the belt, it will be re-used. |
| + | [* 1] Free the y-endstop from the gantry. |
| + | [* 1] Disconnect the y-motor from its cable. |
| + | [* 1] Use side cutters to break the cable ties holding the cables to the gantry. |
| + | [* 1] Free the lead screw coupling from the z-motor shaft. |
| + | [* 1] Finally remove the HDPE linear guides from the gantry and the entire gantry part should now be free. |