Changes to Step #3
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| [title] Disassembling the Gantry | |
| [* 1] Next, remove the tool carriage and Y-belt from the gantry. Do not cut the belt, it will be re-used. | |
| [* 1] Free the y-endstop from the gantry. | |
| + | [* 1] The lead screw bracket at the top of the printer can also be removed, this part can be disregarded as it won't be re-used. |
| [* 1] Disconnect the y-motor from its cable. | |
| [* 1] Use side cutters to break the cable ties holding the cables to the gantry. | |
| [* 1] Free the lead screw coupling from the z-motor shaft. | |
| [* 1] Finally remove the HDPE linear guides from the gantry and the entire gantry part should now be free. |