Changes to Step #5
Edit by Makertech 3D —
Edit approved by Makertech 3D
- Before
- After
- Unchanged
Step Lines
| + | [title] Platform Rails |
|---|---|
| + | [* 7] Use a 2mm metal drill to create 3 holes on either side of the platform. |
| + | [* 2] Place one of the 40cm rails on the platform, 4mm +/-1mm from the edge. |
| + | [* 3] Use a pencil to mark out where you are going to drill. |
| + | [* 5] Secure the rail as shown with three M2 x 10mm bolts and M2 Nyloc Nuts |
| + | [* 8] Be very careful with the carriage, either secure or remove them very carefully. If they fall off and are hit, the ball bearings inside them will escape! |
Image 1
No previous image
Added
Image 2
No previous image
Added
Image 3
No previous image
Added