Changes to Step #10

Edit by Makertech 3D —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Endstop Checks
[* 10] Before starting, make sure that none of the endstops are being triggered.
[* 10] Click on Menu
[* 5] Select terminal.
[* 3] Send an M119 command.
-[* 7] You should receive back that X and Y enstops are open.
+[* 7] You should receive back that X and Y endstops are open.
[* 7] The Z probe should also be open, and the filament sensor should be triggered (as there's no filament loaded).