Changes to Step #23

Edit by Makertech 3D —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Probe Offset
-[* 10] Before beginning this step make sure that the heated bed and hotend are heated up to your desired printing temp. We recommend 220C on the hotend and 70C on the heated bed as a good starting point.
- [* 11] The hotend and platform when hot would have expanded, and therefore the z-offset is different for when the printer is hot versus cold.
+[* 10] Before beginning this step, make sure that the heated bed and hotend are heated up to your desired printing temp. We recommend 220C on the hotend and 70C on the heated bed as a good starting point.
+ [* 11] The hotend and platform, when hot, would have expanded. Therefore, the z-offset is different for when the printer is hot versus cold.
[* 5] Go to the Movement menu and then to the ''Bed Level ''menu.
[* 6] Click on'' P Offset''
[* 2] Press ON to begin the offset calibration.