Changes to Step #11

Edit by Makertech 3D —

Edit approved by Makertech 3D

Before
After
Unchanged

Step Lines

[title] Endstop Checks Cont.
[* 5] Move the tool head to the bottom left as shown.
- [* 11] Both the X and Y endstops should be pressed down.
-[* 10] In the terminal send the M119 command again.
- [* 2] You should receive the following back with the X and X endstops reporting as triggered.
+ [* 11] Both the X and Y endstops should be triggered.
+[* 10] In the terminal, send the M119 command again.
+ [* 2] You should receive the following back with the X and Y endstops reporting as triggered.